10 Easy Steps to Replace the Front Bumper Cover on a 2018 Nissan Murano

Replacing the front bumper cover on a 2018 Nissan Murano may sound like a daunting task, but with the right tools and a bit of patience, it’s a project that can be completed in a few hours. We’ll provide step-by-step instructions on how to remove the old bumper cover, prep the new one, and securely install it. Follow along and restore your Murano’s sleek exterior.

Before you begin, gather the necessary tools: a set of wrenches, a socket wrench with an extension, a pry bar, a Phillips head screwdriver, and some masking tape. Safety first: wear gloves and safety glasses to protect yourself from potential hazards. Identify the bolts and screws that hold the bumper cover in place, usually located along the top, bottom, and sides. Mark their positions with masking tape for easy reassembly later on. Carefully remove the bolts and screws using the appropriate wrench or socket.

Once the bolts and screws are out, you can gently pry the bumper cover loose from the vehicle. Insert the pry bar into the gaps between the cover and the body, working around the perimeter. As you pry, apply even pressure to avoid breaking any clips or tabs. Once the cover is loose, lift it off the vehicle and set it aside. Prepare the new bumper cover by transferring any essential components from the old one, such as fog lights or license plate bracket. Align the new cover with the mounting points on the vehicle and carefully lift it into place. Secure the cover by tightening the bolts and screws that you removed earlier, following the same tightening sequence.

How To Replace Front Bumper Cover On A 2018 Murano

The front bumper cover on a 2018 Murano is a cosmetic piece that helps to protect the front of the vehicle from damage. It is made of plastic and is attached to the vehicle with a series of clips and screws. If the front bumper cover is damaged, it can be replaced by following these steps:

1.

Remove the screws that are located along the top of the bumper cover. There are typically four screws on each side.

2.

Gently pull the bumper cover away from the vehicle. It may be necessary to use a pry tool to help loosen the clips that are holding it in place.

3.

Disconnect the electrical connectors that are attached to the bumper cover. These connectors may be located behind the bumper cover or on the sides.

4.

Remove the bumper cover from the vehicle.

5.

Install the new bumper cover by following the steps in reverse order.

People Also Ask

How much does it cost to replace a front bumper cover on a 2018 Murano?

The cost to replace a front bumper cover on a 2018 Murano will vary depending on the severity of the damage and the location of the repair. However, you can expect to pay between $500 and $1,000 for the repair.

Can I replace the front bumper cover on my 2018 Murano myself?

Yes, it is possible to replace the front bumper cover on your 2018 Murano yourself. However, it is important to note that this repair requires some mechanical experience. If you are not comfortable performing this repair yourself, it is best to take your vehicle to a qualified mechanic.

How long will it take to replace the front bumper cover on my 2018 Murano?

The time it takes to replace the front bumper cover on your 2018 Murano will vary depending on your level of experience and the severity of the damage. However, you can expect to spend between 2 and 4 hours on this repair.