A CV boot, also known as a constant velocity boot, is a rubber or plastic covering that protects the CV joint from dirt, water, and other contaminants. A damaged CV boot can lead to premature wear and tear of the CV joint, so it’s important to replace it as soon as possible if it becomes damaged. Replacing a CV boot is a relatively simple task that can be completed in a few hours with the right tools and materials.
The first step is to remove the old CV boot. To do this, you will need to use a pry bar or a screwdriver to carefully pry the boot off of the CV joint. Once the boot is removed, you will need to clean the CV joint and the axle shaft. Use a wire brush to remove any dirt or debris, and then wipe the surfaces clean with a rag. Apply a thin layer of grease to the CV joint and the axle shaft.
Next, you will need to install the new CV boot. To do this, you will need to slide the boot onto the axle shaft. Start by inserting the smaller end of the boot onto the axle shaft, and then work your way up to the larger end. Once the boot is in place, you will need to secure it with a zip tie or a hose clamp. Finally, you will need to add some grease to the boot. Use a grease gun to apply a generous amount of grease to the inside of the boot. This will help to keep the CV joint lubricated and prevent it from wearing out prematurely.
How To Replace Cv Boot
Replacing a CV boot is a relatively simple procedure that can be completed in about an hour. However, it is important to note that if the CV boot is torn, the CV joint will eventually fail. Therefore, it is important to replace the CV boot as soon as possible if it is torn.
Here are the steps on how to replace a CV boot:
- Park the vehicle on a level surface and engage the parking brake
- Loosen the lug nuts on the wheel that is closest to the CV boot that needs to be replaced
- Jack the vehicle up and remove the wheel
- Pry the old CV boot off of the CV joint using a flathead screwdriver
- Clean the CV joint and the axle shaft
- Apply a thin layer of grease to the CV joint and the axle shaft
- Slide the new CV boot onto the CV joint
- Secure the CV boot with a zip tie or a hose clamp
- Reinstall the wheel and tighten the lug nuts
- Lower the vehicle to the ground
People Also Ask
What are the symptoms of a torn CV boot?
The symptoms of a torn CV boot include:
- A clunking noise when turning
- A vibration when driving
- Leaking grease from the CV boot
How much does it cost to replace a CV boot?
The cost to replace a CV boot will vary depending on the make and model of the vehicle. However, the average cost is between $100 and $200.
Can I drive with a torn CV boot?
It is not recommended to drive with a torn CV boot. If the CV boot is torn, the CV joint will eventually fail. This can lead to a loss of control of the vehicle and an accident.
